Cesoie a ghigliottina idrauliche EHT TSS 4-30

sheet width: 3050 mm
plate thickness: 4.0 mm ST
thickness at Niro-steel: 2.5 mm
cutting angle adjustment: 1.0 °
down holder: 21 Stück
oil volume: 160 Liter
strokes per minute: 18 - 31
Control: ELGO
0: max. 300 bar
voltage: 400 V
main drive: 9.0 kW
weight of the machine ca.: 4800 kg.
dimensions of the machine ca.: 3660 x 2070 x 2140 mm
From a maintenance workshop
Good condition ()

Equipment:
- Electro-hydraulic swing cut sheet metal shear
- Machine frame = all-steel welded construction
- ELGO NC control, control panel at the front left
For positioning the electro-motorized backgauge
Target/actual position value input possible
Adjustment by three-phase motor via toothed belt
- Support table with ball transfer rollers
Grip recesses are located between the table plates
- Front finger guard
- Hydraulically operated sheet metal hold-down clamps
- 1x freely movable foot switch
- Emergency stop button at H5951851 the front
- 1x movable H5951851 scrap diverter (at the rear)
- Operating instructions + circuit diagram

Special accessories included:
- EHT pneumatic sheet metal holding device for thin sheet metal blanks
- 1x EHT extra-long side stop with mm scale & support foot
- 1x EHT front - movable support arm



The data for this ad was created with ModulMWS - the software solution of LogoTech oHG.

seller offer No. resale 1125-9325410