GERMANPLAST horizontal baler 120Ton 6-2... pressa orizzontale 120 Ton 6-22 T/h carta + plastica

AUTOMATIC VERTICAL BINDING BALER, for FILM, WOVEN PP, PET, RIGID AND SOFT PLASTICS, PAPER, CARDBOARD and more, 120 Tons ca. pressing force, 90 kw drive, complete with oil heating and cooling, proportional pressure flow controller, Filling hopper 1.100 x 1.600 mm., Bale size LxWxH 1.100x720 mm (adjustable length), Average throughput rate, - with 30 kg/m3 materials 6-8 Ton/h, - with 50 kg/m3 materials 11-13 Ton/h, - with 120 kg/m3 materials 19-22 Ton/h, 5 vertical-wire binding, Cycle with no material, no twisting : 21 ca, Pre-press flap with 2 x 26 Ton force, Exchangeable bottom plate in hardox in channel and chamber, Machine weight ca 28.500 kg, oil tank capacity : 1.500 kg, General features, common to all balers:, Construction ìn sturdy carbon steel with top EU components., Compact and easy to use, Automatic binding, Fully automatic with adjustable parameters on touch screen panel., A MODEM is installed for quick and cheap remote assistance., PRE-PRESSING : to increase production per cycle and bale size. No cutting knife to sharpen. Bales are heavier and more compacted for better storing., HYDRAULIC UNIT : compact, on the rear of the baler. A block contains all valves and pipes., AXIAL DISPLACEMENT PISTON PUMP, mounted outside of the tank: low noise, short adjustment time, service friendly, high speed, 100% torque transfer., CARTRIDGES : the distribution block control the most important movements: oil temperature remains lower, no pressure surges., PRE PRESS FLAP and PRESS RAM can move simultaneously, so saving time, INCREASED EFFICIENCY : little pressure loss + lower energy consumption + higher capacity., OPTIONAL OIL COOLING SYSTEM : a thermostat will control oil temperature and automatically activate the cooler., OIL TEMPERATURE and OIL LEVEL are controlled: the baler will turn off if the thresholds are reached., WEAR and TEAR on SEALS is reduced and possible prevented by the ball joint which fastens the cylinders, A SIEMENS S7 1200 touch screen panel controls the machine and all of its automatic functions (the machine can always be used in manual mode), availability: ca 6 months from confirmation, options available: perforator, intermidiate hopper, conveyor feed hopper, exit table for bale, support 50 cm., wire coil stand, capacity: 6-22 Tons/h depending on materials and feeding rate, type: pre press